Sebring Sedan V6-3.5L (2009)
9. Engage seat back cover J-Clips
10. Install lower outer shield (2).
11. Install seat belt anchor bolt.
12. Install outboard side shield. See: Body and Frame/Seats/Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation.
13. Install recliner handle. See: Body and Frame/Seats/Service and Repair/Seat Handle - Installation.
14. Connect the battery negative cable.
Rear Center
INSTALLATION
WARNING: Inspect the condition of the shoulder/lap belt. Replace the retractor if the belt is cut, frayed, torn, or damaged in any way. Failure
to inspect the belts could result in improper restraint and could cause occupant serious or fatal injury.
1. Route webbing and bezel through rear shelf trim panel.
2. Install the seat belt anchor and buckle (4) onto the stud.
3. Install nut and tighten to 101 Nm (74.5 ft. lbs.).