Sebring Sedan V6-3.5L (2009)
NOTE: Be certain that the anti-rotation pin on the back of the sensor is engaged in the hole just below the mounting hole in the B-pillar.
2. Connect the electrical connector (4) to the sensor (2).
3. Install the B-pillar lower trim panel See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/B-Pillar Trim
Panel-Installation.
WARNING: Do not connect the battery negative cable See: Testing and Inspection . Serious or fatal injury may result if the system test is not
performed first.
Side - C-Pillar
SIDE - C-PILLAR SENSOR
1. Position the side impact sensor (3) near the inner C-pillar.
2. Connect the harness connector (1) to the sensor (3).
3. Position the sensor onto the C-pillar (2).
NOTE: Be certain that the anti-rotation pin on the back of the sensor is engaged in the clearance hole on the C-pillar below the sensor
mounting hole.
4. Install screw (4) that secures the sensor (3) to the C-pillar (2). Tighten the screw to 8 Nm (71 in. lbs.).
5. Install the rear quarter panel trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment
Trim/Quarter Trim Panel - Installation.
WARNING: Do not connect the battery negative cable See: Testing and Inspection . Serious or fatal injury may result if the system test is not
performed first.
