Sebring Sedan V6-3.5L (2009)
6. SENSOR GROUND CIRCUIT HIGH RESISTANCE
1. Turn the ignition off.
NOTE: When checking circuits at the Powertrain Control Module (PCM), be careful not to damage or distort the connector terminals.
Improper measurement technique could result in poor pin to terminal contact.
2. Using a voltmeter, perform a voltage drop test by backprobing the Sensor Ground circuit at the Engine Coolant Temperature Sensor harness
connector and at the PCM. Make sure the voltmeter leads are connected so that positive polarity is displayed on the voltmeter.
WARNING: When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not
wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
3. Start the engine.
Is the voltage below 0.5 volts?
Yes
-
Go To 7
No
-
Repair the Sensor Ground circuit for excessive resistance.
-
Perform the PCM Verification Test. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test.
7. ENGINE COOLANT TEMPERATURE SENSOR
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Engine Coolant Temperature Sensor and the
Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Search for any Technical Service Bulletins that may apply.
Were any problems found?
Yes
-
Repair as necessary.
-
Perform the PCM Verification Test. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test.
No
-
Replace the Engine Coolant Temperature Sensor.
-
Perform the PCM Verification Test. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests/PCM Verification Test.
