Sebring Sedan V6-3.5L (2009)
Power Window Switch: Testing and Inspection
SWITCH - POWER WINDOW
Any diagnosis of the power window system should begin with the use of the scan tool. For information on the use of the scan tool, refer to the
appropriate Diagnostic Service Manual.
The diagnosis found here applies only to the driver power window switches. If the problem being diagnosed is an inoperative power window switch
illumination lamp, but the power window switch operates as designed, replace the faulty door power window switch.
For complete circuit diagrams, refer to the appropriate wiring information.
1. Disconnect and isolate the battery negative cable.
2. Remove the driver power window switch from the door trim panel. See: Service and Repair/Power Window Switch - Removal.
3. Check the driver door power window switch continuity as shown in the driver power window switch test chart.
DRIVER POWER WINDOW SWITCH TEST - CONVERTIBLE