Sebring Sedan V6-3.5L (2009)
NOTE: Diesel battery harness shown, gasoline battery harness similar.
5. Lower the vehicle.
6. Remove the negative battery cable remote terminal nut (8) from the remote negative battery post. Remove the battery harness negative cable (7)
from the remote negative battery post.
7. Remove the cover (1) from the remote positive battery terminal (2). Remove the starter harness positive cable retaining nut (4) and remove the
cable (3) from the remote positive battery post.
8. Remove the remote positive battery terminal (2) from mounting bracket on the left strut tower (15) by lifting straight up.
9. On diesel engine equipped vehicles:
-
Disconnect the glow plug module connector (14)
-
Disconnect the cabin heater relay connectors (11 and 13)
-
Disconnect the in-line connector to the instrument panel harness (12)
10. Remove the Totally Integrated Power Module (TIPM) from the mounting bracket and turn upside down. Remove the retaining nut (1) and remove
the battery harness cable (2) from the TIPM stud (3).
11. One at a time, trace any remaining battery harness retaining pushpins, fasteners and routing clips until the harness is free from the vehicle.
12. Remove the battery harness from the vehicle.
STARTER HARNESS
