Sebring Sedan V6-3.5L (2009)
CAUTION: The negative battery cable remote terminal (2) must be disconnected and isolated from the remote battery post (1) prior to service
of the vehicle electrical systems. The negative battery cable remote terminal can be isolated by using the supplied isolation hole (3)
in the terminal casing.
1. Remove and isolate the battery harness negative cable (4) on something other than the remote negative battery post (1).
2. Position the starter harness into the vehicle.
3. One at a time, install the starter harness retaining pushpins, fasteners and routing clips until the harness is installed exactly where it was in the
vehicle.
4. Position the starter harness negative cable (2) onto the remote negative battery post (1). Install the retaining nut (3) and tighten to 16.5 Nm (145 in.
lbs.)
