Sebring Sedan V6-3.5L (2009)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley - Installation
INSTALLATION
CAUTION: Do not hammer on power steering pump pulley (2) or pump shaft to install pulley. This action will damage pulley and power
steering pump.
1. Place power steering pump pulley (2) squarely on end of power steering pump shaft.
2. Place Installation Spacer 6936 (1), on top of pump pulley (2).
NOTE: Later build pumps feature a shaft with internal threads that are not as deep as earlier production, thus requiring a stack of washers,
approximately 13 mm (0.5 in.) thickness (3), placed over Spacer 6936 (2), before mounting Installer C-4063C (1) on the pump. To
know if a replacement pump requires the stack of washers, measure the depth of the shaft hole. A later build pump will have a depth
of 20 mm (0.78 in.) while an earlier build pump will have a depth of 32 mm (1.25 in.).
