Sebring Sedan V6-3.5L (2009)
Wheel Bearing: Service and Repair
Rear Hub and Bearing - Installation
FRONT-WHEEL-DRIVE
NOTE: If equipped, make sure the wheel speed sensor mount on the rear of the hub and bearing is directed toward the front of the vehicle.
1. Position the hub and bearing on the brake support plate and knuckle.
2. Install the four bolts (1) securing the hub and bearing (2) to the knuckle. Tighten the bolts to 105 Nm (77 ft. lbs.).
NOTE: Before installing the wheel speed sensor head into the rear of the hub and bearing, inspect the O-ring seal to make sure it is not
dislodged, split, cut or damaged in any way. Replace the O-ring as necessary.
3. If equipped with a wheel speed sensor, install the wheel speed sensor (2) head into the rear of the hub and bearing.
4. If equipped with a wheel speed sensor, install the wheel speed sensor head mounting screw (1). Tighten the screw to 10 Nm (89 in. lbs.).
5. If equipped with rear disc brakes, install the brake rotor, disc brake caliper and adapter. See: Brakes and Traction Control/Disc Brake
System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation
6. If equipped with rear drum brakes, install the brake drum and adjust as necessary. See: Brakes and Traction Control/Drum Brake System/Brake
Drum/Service and Repair/Removal and Replacement/Installation
