Sebring Sedan V6-3.5L (2009)
Power Window Switch: Service and Repair
Power Window Switch - Removal
REMOVAL
FRONT DOOR
1. Disconnect and isolate the negative battery cable.
2. Remove door trim panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Front Door Trim
Panel - Removal.
3. Disconnect switch wire connector.
4. Remove switch assembly.
REAR DOOR
1. Disconnect and isolate the negative battery cable.
2. Remove the interior handle See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Handle/Rear Door Exterior
Handle/Service and Repair/Rear Exterior Door Handle - Removal.
3. Disconnect the electrical connector.
4. Remove the switch from the handle.