Town & Country V6-3.3L Flex Fuel (2008)
Power Seat Motor: Service and Repair
Power Seat Fore Aft Motor - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat
air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may
result in accidental airbag deployment and possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable.
2. Remove the inoperative front seat assembly,See: Service and Repair/Removal and Replacement/Seat - Removal.
3. Remove the flex drive cable cover (2).
a. Using a small flat bladed tool, release the mounting strap (1) that secures the flex drive cable cover (2) to the fore/aft motor (5).
b. Pivot the cover away from the cable and pull it away from the seat frame (4) to disengage the cover slot from the mounting tab (3).
4. Remove the flex drive cable.
a. Carefully bend the flex drive cable at the center and pull the motor end (3) away from the fore/aft motor (1) to disengage.
b. Pull the cable out of the screw drive assembly (2) and remove from seat track.
5. Disconnect the fore aft motor electrical connector.
6. Remove the fore/aft motor to mounting bracket retaining screws (1).
7. Remove the fore/aft motor (3).
8. Remove the short flex drive cable (2) from the seat frame assembly (4).
