Town & Country V6-3.3L Flex Fuel (2008)
NOTE: Outboard side of seat shown. Inboard side similar. Illustration shown with seat back and hinges removed for clarity.
8. Position the seat tracks (2) and eight spacers (1) onto the pivot mechanism (3).
9. Install the four nuts (4) that secure each seat track to the pivot mechanism. Tighten the nuts to 48 Nm (35 ft. lbs.).
10. If equipped with heated seats, engage the wire harness retainers (5) and install the two screws (2) that secure the electrical contact (4) to the
outboard seat riser (3). Tighten the screws securely.
11. Install the seat backSee: Seat Back/Service and Repair/Removal and Replacement/Seat Back - Installation.
12. Install the seat cushion side shieldsSee: Seat Cushion Side Shields - Installation.
13. Install the seat side shieldsSee: Service and Repair/Removal and Replacement/Seat Side Shield - 2nd Row Swivel - Installation.
14. Install the seat into the vehicle.
2nd Row-Stow -N- Go
INSTALLATION
1. Position the seat cushion foam and cover onto the seat cushion frame.
2. Engage the J-straps (1) that secure the seat cushion cover to the cushion frame.
3. Install the seat cushion side shieldsSee: Seat Cushion Side Shields - Installation.
3rd Row-Stow -N- Go
INSTALLATION