Town & Country V6-3.3L VIN R (2003)
Antenna Cable: Description and Operation
ANTENNA BODY AND CABLE
All models use a fixed-length stainless steel rodtype antenna mast, installed at the right front fender of the vehicle. The antenna mast is connected
to the center wire of the coaxial antenna cable, and is not grounded to any part of the vehicle.
To minimize static, the antenna base must have a good ground. The coaxial antenna cable shield (the outer wire mesh of the cable) is grounded to
the antenna base and the radio chassis.
The antenna coaxial cable has an additional disconnect, located near the right end of the instrument panel. This additional disconnect allows the
instrument panel assembly to be removed and installed without removing the radio.
The factory-installed Electronically Tuned Radios (ETRs) automatically compensate for radio antenna trim. Therefore, no antenna trimmer
adjustment is required or possible when replacing the receiver or the antenna.
