Town & Country V6-3.3L VIN R (2003)
10. Remove handle from vehicle.
INSTALLATION
1. Place inside latch handle in position on vehicle.
2. Engage cable end into latch handle.
3. Engage cable casing end into release handle.
4. Install push pin fastener to hold cable into release handle.
5. Engage cable end into release handle mechanism.
6. Engage clip to hold cable end into release handle mechanism.
7. Place latch handle in position on sliding door.
8. Install screw to hold top of inside release handle to sliding door.
9. Install screws to hold bottom of inside latch handle to sliding door.
10. Verify sliding door operation. Adjust as necessary.
11. Install sliding door trim panel.
