Town & Country V6-3.3L VIN R (2003)
Power Door Lock Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove door trim panel. Refer to Body, Door - Front, Trim Panel, REMOVAL.
3. Disconnect wire connector from back of door lock switch.
4. Remove two screws to door lock switch.
5. Remove switch from vehicle.
INSTALLATION
1. Install the switch into the vehicle.
2. Install the two screws to door lock switch.
3. Connect wire connector to back of door lock switch.
4. Install door trim panel. Refer to Body, Door - Front, Trim Panel, INSTALLATION.
5. Connect the battery negative cable.
