Town & Country V6-3.3L VIN R (2003)
Power Seat Switch: Testing and Inspection
Driver Seat Switch Test
1. Remove the power seat switch, refer to the Switch REMOVAL and INSTALLATION procedures in this section.
2. Using an ohmmeter, check pin # 1 of the power seat switch connector for continuity to ground. It should be present, If OK go to Step 3 , If NOT
OK repair the open ground circuit as required.
3. Using an voltmeter, check pin # 5 of the power seat switch connector for approx. 12v. It should be present, If OK go to Step 4 , If NOT OK repair
the open voltage supply circuit as required.
Driver Seat Switch Continuity Test Table
Fig.3 Seat Switch Pin Call-Out
4. Using an ohmmeter, verify the Seat Switch Continuity Test table, using the seat switch connector. If there is no continuity at any of the switch
positions, replace the power seat switch.
