Town & Country V6-3.3L VIN R (2003)
Wheel Speed Sensor: Description and Operation
ABS SWITCHES/SENSORS
Master Cylinder: The master cylinder is a standard tandem compensating port design for ABS and non ABS systems. Traction control vehicles use a
dual center port master cylinder. For proper traction control operation the standard master cylinder must not be used.
A fluid level switch is located in the master cylinder fluid reservoir. The switch closes when a low fluid level is detected. The fluid level switch turns
on the brake warning indicator by grounding the indicator circuit. This switch does not disable the ABS system.
Wheel Speed Sensors and Tone Wheels: One active wheel speed sensor (WSS) is located at each wheel and sends a small DC signal to the control
module (CAB). This signal is generated when a toothed sensor ring (tone wheel) passes by a stationary wheel speed sensor. The CAB converts the
signals for each wheel.
Because of internal circuitry, correct wheel speed sensor function cannot be determined by a continuity or resistance check through the sensor.
The front wheel speed sensor is attached to a boss in the steering knuckle. The tone wheel is an integral part of the front axle shaft. The rear speed
sensor is mounted though the bearing cover and the rear tone wheel is an integral part of the rear bearing hub. The wheel speed sensor air gap is not
adjustable.
The four wheel speed sensors are serviced individually. The front tone wheels are serviced as an assembly with the outer constant velocity (C.V.) joint
housing. The rear tone wheels are serviced as an assembly.
Correct antilock system operation is dependent on tone wheel speed signals from the wheel speed sensors. The vehicle's wheels and tires should all be
the same size and type to generate accurate signals. In addition, the tires should be inflated to the recommended pressure for optimum system
operation. Variation in wheel and tire size or significant variations in inflation pressure can produce inaccurate wheel speed signals; however, the
system will continue to function when using the correct factory mini-spare.
