chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Body - Power Liftgate (PLG) Erratic Operation|Page 173 > < Body - Power Liftgate Does Not Open/Close Properly|Page 168
Page 1
background image

Power Trunk / Liftgate Control Module: Customer Interest
Body - Power Liftgate (PLG) Erratic Operation

NUMBER: 08-005-05

GROUP: Electrical

DATE: January 29, 2005

SUBJECT:
Power Liftgate (PLC) Service

OVERVIEW:
This bulletin involves replacing the PLC module.

MODELS:

2003

(RS)

Town & Country/Caravan/Voyager

NOTE:

This bulletin applies to vehicles equipped with a power liftgate (sales code JRC) built on or before December 18, 2002 (MDH 1218XX).

SYMPTOM/CONDITION:

The customer may describe that the PLC is not operating properly. This may be due to the PLC latch sticking in an unopened state. In this state the
liftgate will not close during a PLC close cycle. The customer may describe that the PLC latch closes prior to the liftgate closing or the liftgate may rise
during typical low speed driving maneuvers.

DIAGNOSIS:

Using the DRBIII(R), determine the part number of the PLC module. If the part number is 04686687AP or higher, no further action is necessary, this
bulletin does not apply and further diagnosis is required. If the part number is not 04686687AP or higher, perform the Repair Procedure.

PARTS REQUIRED:

SPECIAL TOOLS/EQUIPMENT REQUIRED:

NOTE:

An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.

REPAIR PROCEDURE:

1.

Disconnect and isolate the battery negative cable.

2.

Remove left D-pillar trim panel from the vehicle. Refer to the service information available in TechCONNECT. Reference: Service Info, 23 -
Body/Interior/Left D-Pillar Trim Panel - Removal.

Body - Power Liftgate (PLG) Erratic Operation|Page 173 > < Body - Power Liftgate Does Not Open/Close Properly|Page 168