Town & Country V6-3.3L VIN R (2003)
Air Bag Control Module: Service and Repair
Occupant Restraint Controller
REMOVAL
NOTE: Diagnose the ORC using the service/diagnostic manual.
1. Disconnect and isolate the battery negative cable.
2. Remove storage bin from instrument panel. Refer to Body, Instrument Panel, Storage Bin, REMOVAL.
3. Remove three bolts holding ORC to floor bracket.
4. Disconnect the wire connector from ORC.
5. Remove the ORC assembly from vehicle.
INSTALLATION
WARNING: DO NOT INSTALL ORC IF MOUNTING LOCATION IS DEFORMED OR DAMAGED.
CAUTION: Use correct screws when installing the ORC.
1. Install the ORC assembly into vehicle.
2. Connect the wire connector to the ORC.
3. Install three bolts holding ORC to floor bracket. Torque bolts to 7.3 - 9.6 Nm (65 to 85 in. lbs.).
4. Install the storage bin onto the instrument panel. Refer to Body, Instrument Panel, Storage Bin, INSTALLATION.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND
TESTING - AIRBAG SYSTEM FIRST.
