Town & Country V6-3.3L VIN R (2003)
Power Distribution Center (PDC): Service and Repair
Front Control Module Replacement
REMOVAL
1. Disconnect the negative and positive battery cables.
2. Remove the battery thermal guard from the vehicle. Refer to the Battery section for the procedure.
3. Remove the battery from the vehicle. Refer to the Battery section for the procedure.
Fig.3 Releasing Integrated Power Module From Its Mounting Bracket
4. Using a flat-bladed screwdriver, twist the Integrated Power Module (IPM) bracket retaining latch outward to free the intelligent power module
from its mounting bracket (Fig. 3).
Fig.4 Disconnecting IPM
5. Rotate the IPM counter-clockwise to access and disconnect the various electrical connectors (Fig. 4).
6. Free the IPM from its mounting bracket by removing the IPM bracket clips from the hinge. A screwdriver slipped up from under the hinge will
free the clips.
