Town & Country V6-3.3L VIN R (2003)
14.
Remove the tilt head housing from the shaft being careful not to misplace the lower bearing wedge.
15.
Remove the wave washer from the shaft being careful not to misplace it. The wave washer will be reused later.
16.
**TO the base of the shaft, install in order:
a.
The wave washer that was removed in Step # 15.
b.
2 shims.**
c.
The lower bearing wedge (Fig. 1).
17.
Install the revised tilt head assembly, p/n 05083729AA, to the steering shaft. Apply Mopar Lock & Seal adhesive (or equivalent) to both # 45 torx
screw threads and tighten to 11 Nm (100 in. lbs.)
18.
Install the upper bearing wedge to the tilt steering shaft.
19.
Apply a light coat of Mopar silicon spray lubricant, p/n 04318070, on the steering shaft near the snap ring groove. This will facilitate snap ring
installation.
20.
Position the new snap ring onto the shaft near the bearing wedge. With one hand, pull the steering shaft outward and push the snap ring as far
down the shaft as possible.
