Town & Country V6-3.8L (2009)
Parking Assist Warning Indicator: Service and Repair
Park Assist Display - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the upper liftgate opening. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Rear Header
Panel - Removal.
3. Remove the trim from both upper D-pillars. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/D-Pillar
Trim/Removal.
4. Carefully pull down the rear edge of the headliner (5) from the upper liftgate opening header (2) far enough to access the rear park assist display
housing (3) and the display retainer (4).
5. Disconnect the wire harness connector (1) from the connector receptacle on the left end of the display housing.
6. Carefully spread the front and rear edges of the molded plastic retainer far enough to disengage the three retainer tabs from the slots in the display
housing, then lift the retainer off of the display housing.
7. Push the right end of the display out through the lower surface of the headliner, then slide the display toward the right side of the vehicle far
enough to disengage the connector receptacle from the headliner opening.