Town & Country V6-3.8L (2009)
Parking Assist Distance Sensor: Service and Repair
Park Assist Sensor - Removal
REMOVAL
NOTE: The park assist sensors and the sensor spacers (O-rings) are each available for separate service replacement. The sensor brackets are
bonded to and integral to the back side of the rear bumper fascia.
1. Disconnect and isolate the battery negative cable.
2. Remove the bumper fascia (2) from the rear of the vehicle. See: Body and Frame/Bumper/Rear Bumper/Rear Bumper Cover / Fascia/Service and
Repair/Rear Bumper Fascia - Removal.
3. From the back of the fascia, disconnect the wire harness connector (1) from the park assist sensor (4) connector receptacle.
4. Carefully pry the sensor bracket (3) latch features away from the top and bottom latch tabs of the sensor far enough to disengage the sensor from
the bracket.
5. Disengage the resilient O-ring spacer from around the circumference of the sensor membrane protrusion.