Town & Country V6-3.8L (2009)
c. Push down on the sill plate to fully seat all retaining clips.
23. Install the sliding door sill plate.
a. Insert the mounting tab at the front of the sliding door sill plate into the lower B-Pillar trim panel (2).
b. Align the retaining clips on the sill plate (1) with the mounting slots in the door opening (3).
c. Push down on the sill plate to fully seat all retaining clips.
24. Perform the Supplemental Restraint System (SRS) verification test procedure due to removal of the second row seating side impact sensor. See:
Restraint Systems/Service and Repair.
25. Connect the battery negative cable.
26. Perform the power sliding door learn cycle and verify proper system operation, See: Testing and Inspection/Programming and Relearning.
