Town & Country V6-3.8L (2009)
Sliding Door Handle: Service and Repair
Inside Handle Actuator - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the door trim panel. See: Sliding Door Interior Trim Panel/Service and Repair/Door Trim Panel - Removal.
3. Remove the door module assembly. See: Service and Repair/Carrier Plate - Removal.
4. Remove the locking rod bellcrank. See: Sliding Door Latch/Service and Repair/Latch Bellcrank - Removal.
5. Disconnect the electrical connector.
6. Remove the mounting fastener.
7. Remove the actuator (2).
