Town & Country V6-3.8L (2009)
4. Remove the lower B-Pillar trim panel.
a. Using a trim stick C-4755 or equivalent, pull the B-Pillar trim panel away from the B-Pillar (3) to disengage the retaining clips (2).
b. Disconnect the power sliding door B-Pillar switch electrical connector and remove the trim panel.
5. Disconnect the sliding door wire harness connector from the bottom of the sliding door (1).
6. Using door trim panel tool C-4829A or equivalent, remove the wire harness routing clips (2) from the sliding door and the top of the sliding door
lower hinge.
7. Pull locking tab (2) forward to release the rear wire harness chain link clip. Pull the chain link (1) down off of the mounting pin on the sliding door
lower hinge.
