Town & Country V6-3.8L (2009)
Sliding Door Harness: Service and Repair
Power Sliding Door Wiring Harness - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side Supplemental Restraint System (SRS) components. If an
impact sensor is accidentally dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to
observe this warning could result in accidental, incomplete, or improper side SRS component deployment.
1. Position the wire harness (4) into the sliding door track cavity and install the pushpin clips (3) located under the drive assembly.
2. Install the pushpin clip at the B-pillar (2).
3. Connect the sliding door wire harness B-pillar connector (1).
4. Connect the side impact sensor electrical connector (5).
5. Position the power sliding door wire harness chain link (1) onto the mounting pin on the lower side of the sliding door lower hinge. Push locking
tab rearward to secure the rear harness chain link clip (2).
