Town & Country V6-3.8L (2009)
PARTS REQUIRED:
NOTE:
4 Washers are needed for each latch bracket.
REPAIR PROCEDURE:
1. Remove the interior sliding door trim panel. Refer to the detailed removal procedures available in DealerCONNECT > TechCONNECT > : Service
Info > 23-Body > Interior > Doors - Sliding > Panel, Door Trim > Removal.
2. Was the latch cable connected to the interior door handle?
a. Yes >>> Proceed to Step # 4
b. No >>> Re-secure the latch cable and verify the sliding door stays in the full open (latched) position. Did the door stay in the fully (latched) open
position?
3. Did the door stay in the fully (latched) open position?
a. Yes >>> Install the interior sliding door trim panel. Refer to the detailed Installation procedures available in DealerCONNECT >
TechCONNECT > : Service Info > 23-Body > Interior > Doors - Sliding > Panel, Door Trim > Install. Return the vehicle to the customer.
b. No >>> Proceed to Step # 4.
4. Inspect the interior door handle. Was it broken?
a. Yes >>> Replace the broken interior door handle and verify the sliding door stays in the full open (latched) position.
b. No >>> Proceed to Step # 6.
