Town & Country V6-3.8L (2009)
Trunk / Liftgate Hinge: Service and Repair
Hinge - Installation
INSTALLATION
1. If necessary, paint the replacement hinge(s).
2. Position the hinge (2) to the marks on the rear header panel (6) and install the retaining nuts (4 and 5). Tighten the nuts to 33 Nm (24 ft. lbs.).
3. Align the hinge(s) to the marks on the liftgate (3) and install the retaining bolts (1). Tighten the bolts to 33 Nm (24 ft. lbs.).
4. Remove the lifting device and tape from the roof and liftgate.
5. Install the rear header trim panel. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Rear Header Panel - Installation.
6. Verify liftgate alignment.