Town & Country V6-3.8L (2009)
14. Remove the screws (3) securing the power steering pressure hose routing clamp(s) (4.0L engine only uses one) to the rear of crossmember.
15. Remove the bolts (1) securing the steering gear (2) to the crossmember.
16. Support the steering gear (2) using a bungee cord or equivalent to maintain the location of the steering gear in the vehicle once the crossmember is
lowered.
17. Remove the screw securing the left front brake flex hose bracket to the frame rail.
CAUTION: When drawing the location of the crossmember on the underbody in the following step, do not use a sharp object that can damage
the surface of the underbody.
18. Using an appropriate marker, draw an outline (1) as necessary marking the location of the front suspension crossmember on the underbody. This
will aide alignment upon installation.
19. Position a transmission jack under the center of the front suspension crossmember and raise it to support the bottom of the crossmember. Secure
the crossmember to the jack.
