Town & Country V6-3.8L (2009)
Power Seat Motor: Service and Repair
Third Row Power Folding Seat Actuator - Removal
REMOVAL
NOTE: The procedure for replacing the seat leg latch release actuator and cable assembly is the same for both the 60 and 40 third row power
folding seats. The following steps should be performed only on the seat with the inoperative seat leg latch release actuator and cable
assembly.
1. Remove the effected third row power folding seat, See: Service and Repair/Removal and Replacement/Seats, First Row/Seat - Removal.
2. Remove the seat cushion and cover assembly, See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal.
3. Remove the cable assembly from the seat leg.
a. Remove the tie strap holding the switch wire harness and leg latch release cable to the seat leg assembly (3).
b. Push the cable connector (4) down to disengage it from the latch stud.
c. Remove the cable sleeve from the seat leg retaining bracket (5).
d. Pull the cable assembly up out of the seat leg.
e. Repeat this procedure for the other seat leg.
4. Remove the pushpin retainers (1) securing the seat leg latch release actuator and cable assembly (2) to the seat pan (6).
5. Disconnect the seat leg latch release actuator and cable assembly electrical connector (3).
6. Pull the seat leg latch release actuator and cable assembly (2) upward and separate it from the seat pan (6).
