Town & Country V6-3.8L (2009)
2. Install the seat back cover and foam onto the seat back frame.
3. Engage seat back cover J-straps (1) and hook and loop strips (2).
4. Install the seat back panel See: Seat Back/Service and Repair/Seat Back - Installation.
5. Install both armrests See: Interior Moulding / Trim/Arm Rest/Service and Repair/Armrest - Installation.
6. Install the headrest sleeves and headrest See: Head Rest/Service and Repair/Headrest Sleeve - Installation.
Second And Third Row, Bench
INSTALLATION
1. Install the seat back cover and foam onto the seat back frame.
2. Engage the J-straps that secure the cover to the seat back frame.
3. Install the bench seat back panel See: Seat Back Cover - Installation.
4. Install the seat back See: Seat Back/Service and Repair/Seat Back - Installation.
Third Row, Stow-n-Go
INSTALLATION
NOTE: On all leather trimmed seats, back cover can be removed from the back foam pad. On cloth trimmed seats, the back cover does not
separate from the foam pad.
1. Locate stow strap underneath pad/cover and pull the end of the strap through the slit of the pad.cover.
2. Invert cover and install pad on to the back frame.
3. Close up the trim cover lower closeout.
4. Slide the stow and go strap through the bezel. Push bezel onto the back frame slot underneath the cover.
Third Row
INSTALLATION
1. Refer to See: Description and Operation/Seats, Third Row, Power Folding for seat exploded view and call outs.
2. Install the seat back cushion and cover.
3. Install the headrest and sleeves. See: Head Rest/Service and Repair/Headrest Sleeve - Installation.
4. Install the seat back. See: Seat Back/Service and Repair/Seat Back - Installation.
5. Install the seat to the vehicle. See: Service and Repair/Removal and Replacement/Seats, First Row/Seat - Installation.
First Row
REMOVAL
WARNING: Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat
air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
