Town & Country V6-3.8L (2009)
NOTE: Outboard side of seat shown. Inboard side similar. Illustration shown with seat back and hinges removed for clarity.
8. Position the seat tracks (2) and eight spacers (1) onto the pivot mechanism (3).
9. Install the four nuts (4) that secure each seat track to the pivot mechanism. Tighten the nuts to 48 Nm (35 ft. lbs.).
10. If equipped with heated seats, engage the wire harness retainers (5) and install the two screws (2) that secure the electrical contact (4) to the
outboard seat riser (3). Tighten the screws securely.
11. Install the seat back See: Seat Back/Service and Repair/Seat Back - Installation.
12. Install the seat cushion side shields See: Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation.
13. Install the seat side shields See: Service and Repair/Removal and Replacement/Seats, Second And Third Row, Bench/Seat Riser Latch Link -
Installation.
14. Install the seat into the vehicle.
Second Row, Stow-n-Go
INSTALLATION
