Town & Country V6-3.8L (2009)
3. Position the seat cushion front shield (1) to the front of the seat (2) and engage the retaining tabs that secure the shield to the seat.
4. Install the seat back hinge covers See: Seat Cover/Service and Repair/Seat Back Hinge Cover - Installation.
Second Row, Swivel - Lower Swivel
INSTALLATION
NOTE: Outboard side shield shown. Inboard side shield similar.
1. If servicing the outboard seat side shield (1), install the shield over the release handle (5) and install the two screws (4) that secure the center of the
shield to the seat riser (3). Tighten the screws securely.
2. If servicing the inboard seat side shield, position the shield to the seat riser and engage the two retaining tabs that secure the center of the shield to
the riser.
3. Install the screws (2 and 6) that secure the front and back of each seat side shield to the seat riser. Tighten the screws securely.
4. Install the seat into the vehicle.
Second Row, Stow-n-Go
INSTALLATION
1. Position the shield to the side of the seat being serviced and using needle nose pliers, hook the spring leg over the rear rod on the riser.
2. Engage the two plastic clips to the two rods located on the cushion frame and on the riser.
3. Install the seat cushion side shields See: .
Second And Third Row, Bench - Quad Bucket with Cupholder
INSTALLATION
