Town & Country V6-3.8L (2009)
15. If equipped, remove the heated seat wire harness (7) from the child seat restraint bracket (6) located at the rear of the seat cushion frame.
16. Remove the three bolts (5) that secure the child seat restraint bracket to the seat cushion frame and remove the bracket.
17. Remove the six bolts (3, 4 ,8 and 10) that secure the seat tracks to the bottom of the seat cushion frame and remove the tracks from the frame.
Swivel Seat Cushion Frame - Installation
INSTALLATION
NOTE: Right seat shown in illustrations. Left seat similar.
1. Position the seat tracks to the bottom of the seat cushion frame (2) and install the six retaining bolts (3, 4 ,8 and 10). Tighten the bolts to 48 Nm
(35 ft. lbs.).
2. Position the child seat restraint bracket (6) to the seat cushion frame and install the three retaining bolts (5). Tighten the bolts to 27 Nm (20 ft.
lbs.).
3. If equipped, install the heated seat wire harness (7) onto the child seat restraint bracket.
4. Install the seat cushion support (1) onto the seat cushion frame. Engage seat cushion support to the six retaining tabs (9) by using a small punch or
similar tool as a lever. Place the punch or tool through the six holes in the support and into the corresponding holes in the seat cushion frame, then
stretch the support over the retaining tabs.
5. If equipped with heated seats, connect the seat cushion wire harness connector to the heated seat wire harness.
6. Install the seat cushion and cover onto the seat cushion frame (7).
7. Engage the J-hook retainer (3) that secures the seat cushion cover to the front of the seat cushion frame.
8. Engage the four J-hook retainers (2 and 4) that secure the seat cushion cover to the sides of the seat cushion frame.
9. Engage the J-hook retainer (8) that secures the seat cushion cover to the rear of the seat cushion frame.
10. Install the eight spacers (6) onto the mounting studs of the seat tracks (1 and 5).
