Town & Country V6-3.8L (2009)
4. Position the seat track assembly (6) to the bottom of the seat cushion frame (5). Make sure the seat track is properly located and that the plastic
isolators are correctly installed.
5. Engage the four seat track mounting brackets (3) to the bottom of the seat cushion frame and install the retaining bolts (2). Tighten the bolts to 28
Nm (21 ft. lbs.).
6. Install the wire harness (7) to the bottom of the seat cushion frame and to the seat riser (9) and connect the wire harness connectors to the power
seat motors (1) and the seat track position sensor.
7. If equipped, install the heated seat module (4) onto the bottom of the seat cushion frame.
8. Position the seat bottom closeout (3) to the rear of the seat and install the push-pin retainers (1) that secure the two elastic straps (4) to the bottom
of the seat cushion frame (2).
9. Install the inboard seat cushion side shield See: Seat Cushion/Service and Repair/Seat Cushion Side Shields - Installation.
10. Install the seat into the vehicle See: Service and Repair/Removal and Replacement/Seats, First Row/Seat - Installation.
First Row - Manual Front
REMOVAL
NOTE: Outboard seat track shown in illustrations. Inboard seat track similar.
1. Remove the seat from the vehicle and place it on a workbench See: Service and Repair/Removal and Replacement/Seats, First Row/Seat -
Removal.
2. Remove the seat cushion and cover See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal.
3. Remove the riser from the seat track (3) See: Service and Repair/Removal and Replacement/Seats, First Row/Seat Riser - Removal.
4. If servicing the outboard seat track, remove the nut that secures the seat back to the recliner (2).
5. Remove the pivot bolt (1) that secures the seat back to the seat track.
