Town & Country V6-3.8L (2009)
Power Seat Switch: Service and Repair
Power Seat Switch - Removal
Front
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the seat cushion side shield (3), See: Seats/Seat Cushion/Service and Repair/Seat Cushion Side Shields - Removal.
3. Disconnect the power seat switch electrical harness connector (4).
4. Using a small flat bladed tool, gently release the four mounting tabs (1) that secure the power seat switch (2) and separate switch from side shield
(3).
Third Row - Seat Recliner Switch
REMOVAL
NOTE: The procedure for replacing the seat recliner switch is the same for both the 60 and 40 third row power folding seats. The following
steps should be performed only on the seat with the inoperative seat recliner switch.
