Town & Country V6-3.8L (2009)
5. Remove booster push rod (2) from pin (3) on brake pedal. To do so:
a. Position small screwdriver between center tang on power brake booster brake pedal pin retaining clip (1).
b. Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin, then slide retaining clip off brake pedal pin.
c. Discard retaining clip. It is not to be reused. Install NEW retaining clip when assembling.
d. Slide booster push rod (2) off brake pedal pin (3).
6. Remove four power brake booster mounting nuts (3).
7. Remove two nuts (1) fastening pedals assembly (2) to dash panel.
8. Remove pedals assembly (2).
