Town & Country V6-3.8L (2009)
Parking Brake Lever: Service and Repair
Parking Brake Lever - Removal
LEVER
1. Manually release the automatic self-adjusting mechanism tension of the parking brake lever assembly. See: Service and Repair
2. Remove left front door opening sill scuff plate.
3. Remove lower cowl trim.
4. Remove interface connector (3) retaining clips from parking brake lever (1).
5. Disconnect wiring connector (2) at parking brake indicator lamp switch.
6. Remove three mounting nuts (2), then remove parking brake lever (1) from cowl (3) and place it on driver's floor.
NOTE: Prior to removing cable from lever, note cable routing through lever for ease in reassembly.
7. Remove front cable button from lever.