Town & Country V6-3.8L (2009)
Exhaust Pipe: Service and Repair
Exhaust Crossover Pipe - Installation
INSTALLATION
3.3/3.8L
1. Position cross-over pipe (1) to the manifold connections.
2. Position new gasket (3) on left bank (front) pipe connection and loosely install fasteners.
3. Raise the vehicle.
4. Position new gasket on the right bank pipe connection and install fasteners.
5. Tighten right bank upper fastener to 41 Nm (30 ft. lbs.).
6. Tighten right bank lower fastener to 41 Nm (30 ft. lbs.) using a long ratchet extension accessing through the left wheel opening.
7. Install the left front wheel and lower vehicle.
8. Tighten the left bank pipe connection fasteners to 41 Nm (30 ft. lbs.).
9. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
10. Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.
