Town & Country V6-3.8L (2009)
on the actuator with the blend door linkage.
3. Install the two screws (1) that secure the blend door actuator to the air distribution housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
4. If equipped, install the silencer underneath the passenger side of the instrument panel.
5. Reconnect the negative battery cable.
6. Calibrate the A/C-heater control See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System Test.
Rear
INSTALLATION
1. Position the rear blend door actuator (3) onto the rear heater-A/C housing (1). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft with those on the rear blend-air door coupler.
2. Install the two screws (4) that secure the rear blend door actuator to the rear heater-A/C housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (2) to the rear blend door actuator.
4. Install the rear heater-A/C housing See: Housing Assembly HVAC/Service and Repair/Removal and Replacement/Rear HVAC Housing
Installation.
5. Calibrate the A/C-heater control See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System Test.
