Town & Country V6-3.8L (2009)
Evaporator Core: Service and Repair
Front A/C Evaporator - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions may result in serious or
fatal injury.
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator.
NOTE: LHD model shown. RHD model similar.
1. Remove the HVAC housing and place it on a workbench .
2. Disassemble the HVAC housing as necessary to gain access to the A/C evaporator See: Housing Assembly HVAC/Service and
Repair/Overhaul/Disassembly/Front HVAC Housing.
3. Carefully lift the A/C evaporator (2) out of the lower half of the HVAC housing (3).
4. If required, remove the evaporator insulator (2) from around the A/C evaporator.
