Town & Country V6-3.8L (2009)
NOTE: If the foam seal on the top of the inlet housing is deformed or damaged, the seal must be replaced.
4. If required, remove the recirculation door actuator and the recirculation-air door from the air inlet housing.
Front Air Inlet Housing Installation
HOUSING-AIR INLET
NOTE: LHD model shown. RHD model similar.
1. If required, install the recirculation-air door and recirculation door actuator (5) onto the air inlet housing (1). Tighten the actuator retaining screws
to 1.2 Nm (10 in. lbs.).
NOTE: If the foam seal on the top of the inlet housing is deformed or damaged, the seal must be replaced.
2. Position the air inlet housing onto the top of the HVAC housing (3).
3. Install the five screws (2) that secure the air inlet housing to the HVAC housing. Tighten the screws to 1.2 Nm (10 in. lbs.).
4. Connect the HVAC wire harness (4) to the recirculation door actuator.
5. Install the HVAC housing .
Front HVAC Housing Removal
HOUSING-HVAC
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
WARNING: Refer to the applicable warnings and cautions for the A/C system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions may result in serious or
fatal injury.
NOTE: The front HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator and the recirculation
and air distribution housings.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage during this service procedure.
