Town & Country V6-3.8L (2009)
1. Remove the rear heater-A/C housing and place it on a workbench See: Removal and Replacement/Rear HVAC Housing Removal.
2. Carefully remove the foam seal (1) from the flange (5) located at the bottom of the rear heater-A/C housing (3). If the seal is deformed or
damaged, it must be replaced.
3. If required, remove the rear A/C expansion valve (6) from the rear A/C evaporator See: Expansion Valve/Service and Repair/A/C Expansion
Valve - Removal.
4. Remove the four retaining clips (2) and four screws (4) that secure the flange to the rear heater-A/C housing and remove the flange.
5. Remove the screw (5) that secures the rear heater core tube bracket (4) to the rear heater-A/C housing (1).
6. Release the two retaining tabs (2) that secure the rear heater core and tubes (3) in the rear heater-A/C housing.
7. Carefully pull the rear heater core out of the end of the rear heater-A/C housing. If the foam seals on the heater core are deformed or damaged,
they must be replaced.
