Town & Country V6-3.8L (2009)
The traction control indicator is completely controlled by the instrument cluster logic circuit, and that logic will only allow this indicator to operate when
the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the indicator will always be OFF
when the ignition switch is in any position except ON or START. The indicator only illuminates when it is provided a path to ground by the instrument
cluster circuitry. The instrument cluster will turn ON the traction control indicator for the following reasons:
-
Bulb Test - Each time the ignition switch is turned to the ON position the traction control indicator is illuminated for about four seconds as a bulb
test. The entire bulb test is a function of the CAB.
-
Traction Control Indicator Lamp-On Message - Each time the cluster receives an electronic traction control indicator lamp-ON message
from the CAB indicating that the ESP/BAS/TCS has been activated, the traction control indicator will be illuminated. The indicator can be flashed
ON and OFF, or illuminated solid, as dictated by the CAB message. The indicator remains illuminated solid or continues to flash until the cluster
receives a lamp-OFF message from the CAB, or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Actuator Test - Each time the cluster is put through the actuator test, the traction control indicator will be turned ON, then OFF again during the
bulb check portion of the test to confirm the functionality of the LED and the cluster control circuitry.
The CAB continually monitors the ESP OFF switch to determine the proper outputs to the components of the Antilock Brake System (ABS). The CAB
then sends the proper lamp-ON or lamp-OFF message to the ElectroMechanical Instrument Cluster (EMIC) (also known as the Cab Compartment
Node/CCN).
For proper diagnosis of the ESP OFF switch, the ESP/BAS/TCS, the CAB, the EMIC, the CAN data bus or the electronic communication related to
traction control indicator operation a diagnostic scan tool is required. Refer to the appropriate diagnostic information.
