Town & Country V6-3.8L (2009)
-
Select "Misc. Functions"
-
Select "Quicklearn" and follow the on screen instructions.
-
When complete, select "Finish"
Reset Regenerative Filter Timers
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "Reset Regenerative Filter Times" and follow the on screen instructions.
-
When complete, select "Finish"
Set Oil Dilution Mass Value
From the "Home" screen, select "ECU View"
-
Select "PCM/ECM"
-
Select "Misc. Functions"
-
Select "Set Oil Dilution Mass Value" and follow the on screen instructions.
-
When complete, select "Finish"
SECTION 3 - AUTHORIZED MODIFICATION LABEL
NOTE: The following step is required by law when reprogramming a PCM/ECM and/or TCM.
Type the necessary information on the "Authorized Modification Label" and attach near the VECI label.
1. Powertrain Control / Transmission Control Module Part Numbers (Insert P/Ns) Used
2. Change Authority: TSB XX--XX
3. Dealer Code: XXXXX
4. Date: XX-XX-XX
REQUIRED TOOLS/EQUIPMENT:
TECH TIPS and INFORMATION:
1. StarMOBILE(R) Standalone Diagnostic Mode is an efficient way to flash ECUs without having direct access to a network connection. It involves
first copying the flash file to the StarMOBILE(R) device which DOES require a network connection. Once the file has been copied to the
StarMOBILE(R) device, it can be used in a Standalone mode to flash the ECU WITHOUT a network connection.
2. To use the StarMOBILE(R) in Pass-Through Mode requires that your StarMOBILE(R) is connected to the dealerships network via a wired or
wireless connection. For more information on how to use the StarMOBILE in Pass-Through Mode see the StarMOBILE(R) training tutorials
available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools > Training Aids' link, under the 'Training Aids' link.
3. StarMOBILE(R) does not need to be connected to a vehicle when retrieving a flash file for Standalone Mode.
4. Extreme care must be taken when programming a calibration into a generic PCM/ECM. Do not randomly select a calibration. Once a calibration
is selected and programmed, the controller cannot be reprogrammed to a different calibration. The ECU can only be reprogrammed to a more
recent version of that calibration.
5. If the flash process is interrupted or aborted, the flash should be restarted.
