Town & Country V6-3.8L (2009)
Power Trunk / Liftgate Control Module: Service and Repair
Power Liftgate Control Module - Removal
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove the liftgate scuff plate.
a. Using a trim stick C-4755 or equivalent, disengage the liftgate scuff plate retaining clips (1).
b. Carefully disengage the scuff plate end tabs (4) from the left and right quarter trim panels (5).
c. Remove the liftgate scuff plate (3) from the liftgate opening.
4. Remove the upper D-pillar trim.
a. Using a trim stick C-4755 or equivalent, disengage the upper D-pillar trim retaining clips (2).
b. Carefully disengage the upper D-pillar trim end tab (5) from the rear header trim plate.
c. Disconnect the power liftgate D-Pillar switch and third row power folding seat switch electrical connectors (3) (if equipped).
d. Remove the upper D-pillar trim from the liftgate opening.
