Town & Country V6-3.8L (2009)
10. Remove the six nuts (3) that secure the side curtain airbag (4) mounting tabs to the six weld studs (1) on the inner roof side rail.
11. Remove the two nuts that secure the two inflator mounting tabs to the two weld studs (2) of the inflator mounting bracket on the inner roof side rail
and disengage the inflator from the bracket.
12. Remove the side curtain airbag from the vehicle as a unit.
Side Curtain Air Bag - Installation
AIRBAG
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should
be worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation
to the skin and eyes.
WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the side curtain airbag, or
becoming entrapped between the side curtain airbag cushion and the headliner. Failure to observe this warning could result in
occupant injuries upon airbag deployment.
NOTE: The following procedure is for replacement of an ineffective or damaged side curtain airbag. If the airbag is ineffective or damaged,
but not deployed, review the recommended procedures for handling non-deployed supplemental restraints. See: Service and Repair. If
the side curtain airbag has been deployed, review the recommended procedures for service after a supplemental restraint deployment
before removing the airbag from the vehicle. See: Service and Repair.
1. Position the side curtain airbag (4) into the vehicle as a unit.
2. Engage the mounting tabs just ahead of and just behind the airbag inflator over the appropriate weld studs (1) on the inner roof side rail and
loosely secure with two nuts (3).