Town & Country V6-3.8L (2009)
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the passenger airbag from the instrument panel. See: Removal and Replacement/Passenger Air Bag - Removal.
3. Place the passenger airbag on a suitable work surface with the passenger airbag door (1) facing down. If the airbag door will be reused, be certain
to take the proper precautions to prevent the airbag door from receiving cosmetic damage during the following procedures.
4. Disengage each of the 6 hooks (3) of the airbag housing (2) from the windows in the forward wall of the retainer/receptacle (4) on the back of the
airbag door. To disengage the hooks, use hand pressure to push the adjacent edge of the airbag housing firmly and evenly downward into the
airbag door retainer/receptacle, while at the same time pulling outward on that edge of the retainer/receptacle wall.
5. With all of the forward hooks disengaged, roll the forward edge of the airbag housing upward to disengage the 5 lower hooks, then lift the housing
and cushion from the receptacle/retainer on the back of the passenger airbag door.
Passenger Air Bag - Assembly
ASSEMBLY
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, service of this unit should be performed only by Chrysler-trained and authorized dealer service
technicians. Failure to take the proper precautions or to follow the proper procedures could result in accidental, incomplete, or
improper airbag deployment and possible occupant injuries.
WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the passenger airbag, or becoming
entrapped between the passenger airbag cushion and the passenger airbag door. Failure to observe this warning could result in
occupant injuries upon airbag deployment.
WARNING: To avoid serious or fatal injury, the passenger airbag door must never be painted. Replacement airbag doors are serviced in the
original colors. Paint may change the way in which the material of the airbag door responds to an airbag deployment. Failure to
observe this warning could result in occupant injuries upon airbag deployment.
NOTE: The following procedures can be used to replace the passenger airbag door. If the passenger airbag is deployed, the passenger airbag
unit and the airbag door must both be replaced.
