Town & Country V6-3.8L (2009)
Two acceleration-type third row seating side impact sensors (1) are used on this vehicle when it is equipped with the side curtain airbags, one each for
the left and right sides of the vehicle. These sensors are mounted remotely from the impact sensor that is internal to the Occupant Restraint Controller
(ORC). Each side sensor is secured with a screw to the right or left quarter inner panel just above the right or left rear wheel housing within the passenger
compartment. The sensor housing has an integral connector receptacle (3), an integral locating anti-rotation pin, and an integral mounting hole (2).
The right and left third row seating side impact sensors are identical in construction and calibration. However, the connector orientation in the vehicle is
reversed. The connector receptacle faces forward on the right side of the vehicle, and faces rearward on the left side of the vehicle. A cavity in the center
of the molded black plastic impact sensor housing contains the electronic circuitry of the sensor which includes an electronic communication chip and an
electronic impact sensor. The cavity is filled with a potting material to seal and protect the internal electronic circuitry and components. The third row
seating side impact sensors are each connected to the vehicle electrical system through a dedicated take out and connector of the body wire harness.
These acceleration-type third row seating side impact sensors cannot be repaired or adjusted and, if damaged or ineffective, they must be replaced.
