Town & Country V6-3.8L (2009)
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. From in front of the 60 percent third row seat back, insert the shared lower anchor of the third row center anchor buckle (1) and the left outboard
seat belt buckle (3) through the clearance hole in the seat cushion trim cover to the back of the third row seat cushion frame (5).
2. From the behind the seat back, engage the double buckle unit lower anchor over the stud (4) on the cushion frame.
3. Install and tighten the nut (2) that secures the double buckle lower anchor to the stud. Tighten the nut to 39 Nm (29 ft. lbs.).
4. Engage the J-clip retainers that secure the seat cushion trim cover to the rear edge of the seat cushion frame.
5. Reinstall the ends of the plastic grocery bag retainer onto the seat hinge cover at each side of the seat cushion.
6. Install and tighten the screws that secure the grocery bag retainer to the underside of the rear edge of the seat cushion frame.
Third Row Bench Single Buckle
THIRD ROW BENCH SINGLE BUCKLE
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. Pull the forward edge of the trim cover (2) away from the side of the seat cushion (4) far enough to access the mounting stud on the seat cushion
frame for the single third row seat belt buckle (1) lower anchor.
2. Position the buckle lower anchor onto the stud.
3. Install and tighten the nut (3) that secures the buckle lower anchor to the stud. Tighten the nut to 39 Nm (29 ft. lbs.).
